Running The Ssp 7.1 Setup And Control Software - Extron electronics SSP 7.1 User Manual

Running the SSP 7.1 Setup and Control Software
Connect to device? Dialog Box
The computer must be connected to the SSP 7.1 using either the RS-232 captive screw
connector on the rear panel or the Config port on the front panel.
To start the program, click on the desktop icon or click on the Windows
All Programs > Extron Electronics > SSP7.1 > SSP7.1
Connect to device?
To work offline in Emulate mode, select the
directly to the SSP 7.1, leave the box unchecked. See the previous section,
Modes
If you choose to work directly with the SSP 7.1:
1.
2.
3.
If you select Emulate, click
dialog box (shown below) opens.
on the previous page, for a description of each mode.
The Device Name ( SSP 7.1
no other selections are available for these fields.
Select the correct
Com Port
Connect to device?
Emulate / Work of ine
Device Name:
SSP 7.1
Connection Method:
RS-232
Com Port:
COM1
Baud Rate
38400
Connect
Stop prompting me to connect upon startup
Figure 19. Connect to device? Dialog Box — Live Mode
Click (or to exit the program).
Connect Cancel
Work Offline
Connect to device?
Emulate / Work of ine
Device Name:
SSP 7.1
Connection Method:
RS-232
Com Port: COM 1
9600
Baud Rate
Work Offline
Stop prompting me to connect upon startup
Figure 20. Connect to device? Dialog Box — Emulate Mode
NOTE: When
Emulate/Work Offline
by a button. The program does not connect to the sound processor.
Work Offline
Instead, it allows you to create a configuration that can be saved as a file and used to
update the configuration of the sound processor when the program is in
Emulate/Work offline
) and Connection Method (
and (default
Baud Rate 38400
?
Cancel
(or to exit the program).
Cancel
?
Cancel
is selected, the
SSP 7.1 • Setup and Control Software
button and select
Start
. When the program launches, the
checkbox. To connect
Live and Emulate
RS-232 ) are already entered and
).
button is replaced
Connect
Live mode.
22