Extron electronics SSP 7.1 User Manual page 33

Input and Output information panel — The Input
•
and Output information panel, on the right side of the
screen, is visible in all tabs and provides information
about:
The current input
•
Selected input channel
•
Source format
•
Sampling frequency
•
Encoded channels
•
The current output
•
Speaker configuration
•
Listening mode
•
Mode override selection
•
Master volume
•
Mute
•
NOTE:
While the Master Volume
status can be adjusted using the slider bar and
button in this panel, the
status information in this information bar is read
only.
Input status — The
Input
•
indicates which input channel
is being used. Underneath
are three lines of information
about the source format, the
sampling frequency, and encoded
channels.
The box underneath highlights
the active channels for the audio
source in blue.
= left front
L
•
= center
C
•
= right front
R
•
LS = left surround
•
= right surround
RS
•
= surround (only available
S
•
with 3/1 or 2/1 sources):
LS and RS carry a mono
surround signal.
= surround back
SB
•
= low frequency effect (primarily used for subwoofer channel output)
LFE
•
For more information about configuring the
see page 6. To understand more about
value and Mute
and
Input Output
box
Figure 27.
Input Status
Source Format
Source Formats, see page 52.
SSP 7.1 • Setup and Control Software
Figure 26.
Input and Output
Information Bar
from the SSP 7.1 front panel,
25