Extron electronics SSP 7.1 User Manual page 44

5. Use any of these methods to adjust the output trim for each speaker.
Grab and drag the slider bar to adjust output trim in 1 dB increments.
•
Click on one of the output trim slider controls to activate it and use the up and down
•
arrows beside the text box to adjust it in 1 dB increments.
Click on one of the output trim slider controls to activate it and use the up and down
•
keys on the keyboard to adjust it in 1 dB increments.
Click on one of the output trim slider controls to activate it and use the <page up> and
•
<page down> keys on the keyboard to adjust it in 5 dB increments.
Highlight the value in the text box, type a number (omit the dB), and press <Enter> on
•
the keyboard.
The Reset button returns the output trim values for all speakers to the default value (0 dB).
Input and Output information bar
The Input and Output information panel
detail starting on page 25.
Speaker Equalization Tab
After the
Testing & Output Trim
Figure 44. Speaker Equalization Tab
The
Speaker Equalization
default frequency values correspond to a nine-band graphic equalizer, which provides a starting
point for refining the output signal from each speaker channel.
All the properties of the SSP 7.1 parametric EQs can be defined by the user.
Speaker selection
Select the speaker to be configured from the drop-down menu.
Figure 45. Speaker Selection Menu
is available from all GUI tabs and is described in
tab, configure the
Speaker Equalization
tab provides nine parametric EQs for each output channel. The
SSP 7.1 • Setup and Control Software
tab settings.
36