Extron electronics SSP 7.1 User Manual page 52

DTS Neo:6 settings
Center Image Settings
These controls set the center image for DTS Neo:6
Cinema and DTS Neo:6 Music listening modes. More
information about this listening mode is found on page
69.
The sliding bars adjust the center image control settings:
: - (the default is
DTS Neo:6 Cinema 0 10
DTS Neo:6 Music : 0 - 10 (the default is
Setting the control to creates the effect of spreading
0
out the audio signal across the front speakers. Setting the
control to creates the effect of centralizing the audio
10
signal.
For more information, see Center Image control
page 60.
Mono Settings
Two advanced configurations apply only to mono
sources or outputs.
Analog Source (applies to Input 5 only)
A mono signal may be input as left channel only, right
channel only, or the sum of left and right channels
(both channels input identical mono signals). These
controls allow the user to decide whether the
, , or
Only Right Only L+R (Sum)
becomes the source for the mono decoding mode.
The default is .
L+R (Sum)
Output Channels
These buttons let the user select whether mono
signals are output to the center channel (
Only ) or a dual mono signal is sent to the right and
left front channels (
Front L+R Only
.
Center Only
Input and Output information bar
The Input and Output information panel
detail starting on page 25.
)
10
3 )
Figure 60.
on
Left
summed input
Figure 61.
Center
). The default is
is available from all GUI tabs and is described in
SSP 7.1 • Setup and Control Software
DTS Neo:6 Settings
Mono Settings
44