Installing The Cable Management Tray - Dell PowerEdge R930 Owner's Manual

a Memory riser and fan cage
b Cooling fans
c Memory risers
d Memory riser blanks, if removed
2 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a memory riser
Removing a cooling fan
Removing the memory riser and fan cage
Removing a memory riser blank
Installing the memory riser and fan cage
Installing a cooling fan
Installing a memory riser
Installing a memory riser blank

Installing the cable management tray

After working inside your system
Installing the cable management tray
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the following:
a Memory risers
b Memory riser blanks, if installed
c Cooling fans
d Memory riser and fan cage
Steps
1 Position the cable management tray above the heat sinks.
2 Lower one end of the cable management tray, and insert the cable management tray hooks into the slots on the side of the chassis.
3 Lower the other end of the cable management tray, and press the cable management tray hooks so that they snap into the slots on
the side of the chassis.
4 Open the cable management tray by using the release tab.
5 Route the cables through the cable management tray.
6 Close the cable management tray.
90 Installing and removing system components