Integrated Storage Controller Card - Dell PowerEdge R930 Owner's Manual

Hide thumbs Also See for PowerEdge R930:
Table of Contents

Advertisement

NOTE:
Temporarily label each SD card with its corresponding slot before removal.
Steps
1
Locate the internal dual SD module (IDSDM) connector on the system board. To locate the IDSDM connector, see the System board
connectors section.
2
Align the IDSDM with the connector on the system board.
3
Push the IDSDM until it is firmly seated on the system board.
Figure 67. Installing the optional internal dual SD module
1
IDSDM
3
connector
Next steps
1
Install the SD cards.
NOTE:
Re-install the SD cards into the same slots based on the labels you had marked on the cards during removal.
2
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
System board connectors
Installing an internal SD card
After working inside your system

Integrated storage controller card

Your system supports both single and dual storage controller card options. Your system includes a dedicated expansion card slot on the
system board for the primary integrated SAS or PERC controller card. The Integrated storage controller card provides the integrated
storage subsystem for your system's internal hard drives. Install the secondary storage card must be installed in slot 8. The controller
supports SAS and SATA hard drives, and also enables you to set up the hard drives in RAID configurations as supported by the version of
the storage controller included with your system.
128
Installing and removing system components
2
pull tab

Advertisement

Table of Contents
loading

Table of Contents