Installing The Network Daughter Card Riser - Dell PowerEdge R930 Owner's Manual

Figure 57. Removing the NDC riser
1 NDC
3 connector on the system board
Next steps
1 Install the NDC riser.
2 If removed, install the left expansion card riser.
3 Re-connect all the disconnected cables
4 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the left or right expansion card riser

Installing the Network Daughter Card riser

Installing the left or right expansion card riser
After working inside your system
Installing the Network Daughter Card riser
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
116 Installing and removing system components
2 PCI retention rocker