Figure 69. Installing the integrated storage controller card
1
clamp slot on the power supply bay
3
SAS connector
5
storage controller card
Next steps
1
Install the NDC riser.
2
If removed, install the left expansion card riser.
3
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing the Network Daughter Card riser
Installing the left or right expansion card riser
After working inside your system
Processors and heat sinks
Use the following procedure when:
•
Removing and installing a heat sink
•
Installing an additional processor
•
Replacing a processor
NOTE:
To ensure proper system cooling, you must install a processor blank in any empty processor socket.
2
clamp
4
storage controller battery connector
6
storage controller card connector on the system board
Installing and removing system components
131