Installing A Memory Riser - Dell PowerEdge R930 Owner's Manual

Installing a memory riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: Before installing the memory riser, ensure that the memory module socket ejectors are in the locked position. Also
ensure cables from the hard drive backplane are placed in the cable latch and closed.
CAUTION: Use the memory riser handle, while installing and removing the memory risers. Handling the memory riser without
using the handle may cause injury.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If installed, remove the memory riser blank and the protective cap on the memory riser connector.
Steps
1 Hold the memory riser handle in the direction of the air flow, and align the memory riser with the guides on the memory riser and fan
cage.
2 Insert the memory riser into the guides on the memory riser and fan cage until it is fully seated in the connector on the system board.
NOTE: If the memory riser is not seated properly, the memory riser handle will not get locked.
3 Press the memory riser handle until the handle lock clicks into place.
74 Installing and removing system components