Installing The System Board - Dell PowerEdge R930 Owner's Manual

Related links
Safety instructions
Before working inside your system
Removing the cable management tray
Removing a cooling fan
Removing a memory riser
Removing the memory riser and fan cage
Removing the fan tray
Removing a heat sink
Removing a processor and heat sink blank
Removing a processor
Removing an AC power supply unit
Removing the power supply unit bay
Removing the power distribution board
Removing the Network Daughter Card riser
Removing the left or right expansion card riser
Removing an expansion card from expansion card risers
Removing the integrated storage controller card
Replacing the optional internal USB memory key
Removing the hard drive backplane
Removing the optical drive

Installing the system board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified
service technicians.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Unpack the new system board.
Steps
1 Holding the memory riser guide and metal bracket, lower the system board into the chassis.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
NOTE: Exercise caution when you install the system board into the chassis, because installing the system board may cause
damage to the optical drive cable connector that is connected to front of the system board.
2 Push the system board toward the back of the chassis until the release pin on the board clicks into place.
NOTE: Ensure that the two tabs at the back of the system board engage with the slots on the chassis.
174 Installing and removing system components