Installing The Cable Management Tray - Dell PowerEdge R930 Owner's Manual

3. cable management tray
Next steps
Install the cable management tray.
Related Tasks
Removing a memory riser
Removing a cooling fan
Removing the memory riser and fan cage
Removing a memory riser blank

Installing the cable management tray

Installing the cable management tray
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you follow the
Steps
1. Position the cable management tray above the heat sinks.
2. Lower one end of the cable management tray, and insert the cable management tray hooks into the
slots on the side of the chassis.
3. Lower the other end of the cable management tray, and press the cable management tray hooks so
that they snap into the slots on the side of the chassis.
4. Open the cable management tray by using the release tab.
5. Route the cables through the cable management tray.
6. Close the cable management tray.
Next steps
1. Install the following:
a. Memory riser and fan cage
b. Cooling fans
c. Memory risers
d. Memory riser blanks, if removed
2. Follow the procedure listed in
Related Tasks
Installing the memory riser and fan cage
Installing a cooling fan
Installing a memory riser
Installing a memory riser blank
Safety instructions.
After working inside your system.
55