Installing The Chassis Intrusion Switch - Dell PowerEdge R930 Owner's Manual

3 hook on the NDC riser bracket
Next steps
1 Install the chassis intrusion switch
2 Install the NDC.
3 Install the NDC riser.
4 Follow the procedure listed in the After working inside your system section.
.
Related links
Safety instructions
Before working inside your system
Removing the Network Daughter Card riser
Removing the network daughter card

Installing the chassis intrusion switch

After working inside your system
Installing the chassis intrusion switch
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Remove the NDC riser.
4 Remove the NDC.
Steps
1 Slide the chassis intrusion switch into the intrusion switch slot.
2 Connect the chassis intrusion switch cable to the connector on the Network Daughter Card (NDC) riser card.
3 Route the cable through the hook on the NDC riser bracket.
122 Installing and removing system components
4 chassis intrusion switch connector