Codes For Ip Configuration - Aastra OpenCom 510 User Manual

Configuration
Forced logoff of another user by the administrator
The configuration of the system can always only be edited by one user. Working on
the configuration in parallel is not possible. This ensures that no configuration
conflicts arise.
If the user "Administrator" logs in and another user with administration rights is
already logged in, then the administrator can forcibly log the other user off in
order to configure. This functionality, for example can be used, when configuring
remotely, when a user has forgotten to log out.
In order to forcibly log a user off:
1. The "Administrator" user logs on with the administration password.
2. They open the Configurator.
A message shows which user is currently configuring the system.
3. The administrator clicks on the Take over config rights button.
The other user can make no further modifications of the configuration.

8.2.8 Codes for IP Configuration

The IP configuration of the OpenCom 510 is performed on the Web console in the
Configurator, in the NET Configuration: LAN menu.
In the event that the IP configuration of the OpenCom 510 has to be changed and
access via the Web console is not possible, you can also use a code digit procedure
to change these basic settings. Entry can be made from an analogue telephone, an
ISDN telephone and from system telephones.
Set IP address
H *182 Z
Z * Z
(www) (xxx)
Set NET mask
H *183 Z
Z * Z
(www) (xxx)
90
*
(system PIN)
* Z * Z
(yyy)
*
(system PIN)
* Z * Z
(yyy)
Configuring the OpenCom 510
#
(zzz)
#
(zzz)