Mx+S01-8 - Aastra OpenCom 510 User Manual

Modules
LED 1: Constantly yellow
LED 2: Constantly green
Flashing yellow
Constantly red
LED 3: Constantly green
LED 4: –
Operational Information
The MT+S2M1-1 interface card can be exchanged during operation, i.e. without
powering down the system. However, the slot must first be deactivated in the
Configurator in the web console (see Installing Interface Cards starting on
page 31).
7.6

MX+S01-8

Field of Application
The MX+S01-8 interface card provides eight 8 S
either external connections, i.e. to connect the OpenCom 510 to a digital network
(PSTN, Public Switch Telephony Network), or internal connections, i.e. to connect
digital terminals (ISDN telephones, ISDN fax machines etc.) to the OpenCom 510.
The MX+S01-8 interface card can be installed in any of the slots (1 to 12) of the
OpenCom 510 (see Slots starting on page 27).
Technical Information
■
The MX+S01-8 interface card can also be installed in a slave system.
At least one connection established through
the interface card is active.
The interface card is operational; the slot has
been activated (flickering is normal).
The interface card is ready, but the slot has not
been activated or the interface card has not
been configured yet.
New software is being loaded onto the interface
card. If the LED lights up red for an extended pe-
riod of time, there may be a fault.
The interface card is providing the system clock
signal (indicated only in the master system and
only on an interface card).
Not used
interfaces which can be used for
0
MX+S01-8
71