Internal Sip Telephony - Aastra OpenCom 510 User Manual

Voice over IP (VoIP)
6. Call up the PBX Configuration: Trunks: Route: New page once again. Enter
"SIP", for example, under Name, under Code the number "8" and select the SIP
account that was just configured for Bundle/SIP trunks 1. The SIP account is
now available with the dialling prefix "8". To use the SIP account by default, call
up the page PBX Configuration: Trunks: Route and select the route External
trunk. Under Bundle/SIP trunks 1, select the SIP account you have just set up.
Click on Apply.
7. Check that the SIP connection is active on the Systeminfo: PBX: Trunks page.
Also check the SIP licence count on the SYS Configuration: Licences page.
Check the functionality by making an external call. You should assign the relevant
external number of the SIP account to the internal numbers on the page PBX Con-
figuration: Call distribution: Incoming.

10.1.3 Internal SIP telephony

SIP telephones connected via LAN or SIP telephony software on LAN workstation
computers can also be operated with the OpenCom 510.
1. Install a Media Gateway card (see MG+ETH1-1 starting on page 115).
2. Call up the Configurator and go to the page PBX Configuration: Ports: Slots.
Click on the corresponding slot. Under Configured, select MGC VoIP. Optional:
enter an IP address from the OpenCom 510 IP network which is not being used,
such as 192.168.99.253 under IP Address Configured. Click on Apply.
3. Call up the PBX Configuration: Devices: VoIP Phones page in the Configu-
rator.
Tip:
4. Call up the User Manager: User page. Assign the new internal call number to a
user. Internal SIP telephones can also be operated by users without code
words. If you do not assign the call number of the SIP telephone to a user, you
can only configure a "Guest" user account on the SIP telephone.
108
Note: The PBX Configuration: Trunks menu page is only
displayed if you activate the Level: Expert option on the
opening page of the Configurator.
Click on New. Select the "SIP" option under Type and enter an
internal Phone No. Click on Apply.
Quick start