Ms+Upn1-8 - Aastra OpenCom 510 User Manual

Mounting and commissionin
Hide thumbs Also See for OpenCom 510:
Table of Contents

Advertisement

Modules
The LEDs indicate the following:
LED 1: Constantly yellow
LED 2: Constantly green
Flashing yellow
Constantly red
LED 3: Constantly green
LED 4: Constantly yellow
Operational Information
The MX+S01-8 interface card can be exchanged during operation, i.e. without
powering down the system. However, the slot must first be deactivated in the
Configurator in the web console (see Installing Interface Cards starting on
page 31).
All three protocol layers can be individually configured as master or slave for each
S
interface.
0
The S
interfaces can be configured as DSS1-PP, DSS1-PMP or Q.SIG lines.
0
7.7

MS+UPN1-8

Field of Application
The MS+UPN1-8 interface card provides eight U
system terminals; however, it is not possible to connect DECT base stations.
At least one connection established through
the interface card is active.
The interface card is operational; the slot has
been activated (flickering is normal).
The interface card is ready, but the slot has not
been activated or the interface card has not
been configured yet.
New software is being loaded onto the interface
card. If the LED lights up red for an extended pe-
riod of time, there may be a fault.
The interface card is providing the system clock
signal (indicated only in the master system and
only on an interface card).
The interface card is running a combination of
subscriber and trunk connections, i.e. both in-
ternal and external S
figured.
interfaces for connecting
pn
MS+UPN1-8
interfaces have been con-
0
73

Advertisement

Table of Contents
loading

Table of Contents