Aastra OpenCom 510 User Manual page 91

Configuration
Use the following code digit procedure on a standard terminal or a system tele-
phone to activate internal remote maintenance access for the service centre/
authorised dealer:
Remote configuration on (log-on with administrator password)
H * 1 9 * Z
Remote configuration on (log-on with temporary password)
H * 1 9 * Z
Remote configuration off
H # 1 9 #
Activation is automatically cancelled 30 minutes after the last configuration
activity.
Please note:
Using remote configuration, all OpenCom 510 settings (with the exception of the
system PIN) can be edited or updated. New software versions of the OpenCom 510
and the software for the connected system terminals and base stations can also be
installed (see the SYS Configuration: Firmware menu in the Configurator).
For security reasons, settings in the Configurator, Net Configuration should only
be edited on site to avoid malfunctions or failures in the customer's LAN (e.g. due
to IP address conflicts). Refer to the chapter entitled Configuration Examples
starting on page 94, where interaction between the OpenCom 510 and a LAN is
explained.
Note: If you do not wish to let the customer service centre/
authorised dealer know the administrator password, you can
define a temporary password for remote configuration with
at least five digits.
#
(system PIN)
* Z
(system PIN)
Note: During remote configuration, the OpenCom 510 is
blocked for RAS access by any further users.
The system PIN is preset to "0000" and it is absolutely imper-
ative that the system administrator changes it to prevent un-
desirable remote maintenance.
Configuring the OpenCom 510
(temporary password)
#
89