PBX Networking
13. PBX Networking
OpenCom 510 provides all the features necessary for PBX networking. You need
PBX networking in the following cases:
■
To operate the OpenCom 510 as a subsidiary system on another PBX. This will
also allow you to use the OpenCom 510 as a DECT server, for example.
■
To network the OpenCom 510 with an OpenCom 1000. In this way you can use
the OpenCom 510 as a PBX for a branch office, for instance.
■
To network several OpenCom 510s into a PBX system.
■
To use flexible configuration possibilities of trunk lines for a OpenCom 510.
All settings that affect the configuration of PBX networking can be found in the
Configurator menu PBX Configuration: Trunks and in the PBX Configuration:
System: Settings dialogue under System linking. Refer also refer to the corre-
sponding help topics in the OpenCom 510 online help.
You can use ISDN point-to-point connections (Q.SIG or DSS1 protocol) or IP con-
nections (Q.SIG-IP protocol) for TK system networking.
13.1
Connections
Networking two or more TK systems means interconnecting them. The
OpenCom 510 allows you to use the following connections:
■
ISDN trunk lines
Note: If you do not need the features of PBX networking,
the simplified configuration is sufficient in most cases. For
this purpose, assign the preconfigured trunk groups (bun-
dles) Multi-terminal access or System access to the ports.
The preconfigured route called External trunk now makes it
possible to seize an external line immediately or by first dial-
ling the prefix "0". You can rename the preconfigured bun-
dle and the preconfigured route if required, but you cannot
delete them.
Connections
149