Factory Settings - Aastra OpenCom 510 User Manual

Mounting and commissionin
Hide thumbs Also See for OpenCom 510:
Table of Contents

Advertisement

Factory Settings

2.
Factory Settings
The OpenCom 510 is delivered with the following basic settings and activated fea-
tures. We recommend that you configure the OpenCom 510 to meet your specific
requirements before putting it into operation (see Configuration starting on
page 82).
Tip:
2.1
Telephony Functions
The OpenCom 510 is pre-configured for use in Germany.
Analogue terminals: The dialling mode (pulse dialling or DTMF) is detected
automatically.
Incoming external calls are signalled at all corded terminals connected to the
system.
The system PIN, which is used for remote-programmable call forwarding, for
example, is "0000".
2.2
Authorisations
Authorisations determine which functions can be used at the terminals connected
to the OpenCom 510. Authorisations are configured for so-called user groups;
users and their terminals are allocated to these groups.
Three user groups are preset: "Administrators", "Standard" and "Guests". "Adminis-
trators" have access to all functions of the OpenCom 510 and unrestricted configu-
ration rights. Users in the "Guests" group cannot configure the OpenCom 510, are
not able to make external calls, and have only restricted use of the terminal func-
tions of the OpenCom 510. The "Standard" user group, because of its default set-
tings, is well suited as a starting point for the creation of user groups for normal
users of the system (e.g. the staff members of a company).
Notes on the functions listed below can be found in the glos-
sary (provided as a PDF file on the system CD).
Note: When the OpenCom 510 is first put into operation, all
connected terminals are in the "Administrators" group until a
Telephony Functions
15

Advertisement

Table of Contents
loading

Table of Contents