Configuring An Ipv6 Multicast Group Policy; Adjusting Mld Performance; Configuring Mld Query And Response Parameters - HP VSR1000 Configuration Manual

Step
Enter system view.
1.
Enter interface view.
2.
Configure a static group
3.
member.

Configuring an IPv6 multicast group policy

This feature enables an interface to filter MLD reports by using an ACL that specifies IPv6 multicast
groups and the optional sources. It is used to control the IPv6 multicast groups that the hosts
attached to an interface can join.
This configuration does not take effect on static group members.
To configure an IPv6 multicast group policy:
Step
Enter system view.
1.
Enter interface view.
2.
Configure an IPv6 multicast
3.
group policy on an interface.

Adjusting MLD performance

Before adjusting MLD performance, complete the following tasks:
•
Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices can
interoperate at the network layer.
•
Configure basic MLD features.

Configuring MLD query and response parameters

The following are MLD query and response parameters:
•
MLD querier's robustness variable—Number of times for retransmitting MLD queries in case
of packet loss. A higher robustness variable makes the MLD querier more robust, but increases
the timeout time for IPv6 multicast groups.
•
MLD startup query interval—Interval at which an MLD querier sends MLD general queries at
startup.
•
MLD startup query count—Number of MLD general queries that an MLD querier sends at
startup.
•
MLD general query interval—Interval at which an MLD querier sends MLD general queries to
check for IPv6 multicast group members on the network.
•
MLD last listener query interval—In MLDv1, it sets the interval at which a querier sends
multicast-address-specific queries after receiving a done message. In MLDv2, it sets the
Command
system-view
interface interface-type
interface-number
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
Command
system-view
interface interface-type
interface-number
mld group-policy
ipv6-acl-number
[ version-number ]
237
Remarks
N/A
N/A
By default, the interface is not a
static group member of any IPv6
multicast groups.
Remarks
N/A
N/A
By default, no IPv6 multicast
group polices exist on an
interface, and hosts attached to
the interface can join any IPv6
multicast groups.