HP VSR1000 Configuration Manual page 40

<Hub1>system-view
[Hub1]ospf
[Hub1-ospf-1]area 0.0.0.0
[Hub1-ospf-1-area-0.0.0.0]network 10.1.1.0 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0]network 1.1.1.1 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0]quit
[Hub1-ospf-1]quit
# On Hub 2, configure OSPF.
<Hub2>system-view
[Hub2]ospf
[Hub2-ospf-1]area 0.0.0.0
[Hub2-ospf-1-area-0.0.0.0]network 2.2.2.2 0.0.0.255
[Hub2-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Hub2-ospf-1-area-0.0.0.0]quit
[Hub2-ospf-1]quit
# On Spoke 1, configure OSPF.
<Spoke1>system-view
[Spoke1]ospf
[Spoke1-ospf-1]area 0.0.0.0
[Spoke1-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Spoke1-ospf-1-area-0.0.0.0]network 20.1.1.0 0.0.0.255
[Spoke1-ospf-1-area-0.0.0.0]quit
[Spoke1-ospf-1]quit
# On Spoke 2, configure OSPF.
<Spoke2>system-view
[Spoke2]ospf
[Spoke2-ospf-1]area 0.0.0.0
[Spoke2-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Spoke2-ospf-1-area-0.0.0.0]quit
[Spoke2-ospf-1]quit
Configure IP multicast:
4.
a. Configure Hub 1
# Enable IP multicast routing.
<Hub1>system-view
[Hub1]multicast routing
[Hub1-mrib]quit
# Enable PIM-SM on Loopback 0 and GigabitEthernet 1/0/2.
[Hub1]interface loopback 0
[Hub1-LoopBack0]pim sm
[Hub1-LoopBack0]quit
[Hub1]interface gigabitethernet 1/0/2
[Hub1-GigabitEthernet1/0/2]pim sm
[Hub1-GigabitEthernet1/0/2]quit
# Enable PIM-SM and NBMA mode on tunnel interface tunnel1.
[Hub1]interface tunnel 1
[Hub1-Tunnel1]pim sm
[Hub1-Tunnel1]pim nbma-mode
32