Displaying And Maintaining Multicast Vpn - HP VSR1000 Configuration Manual

to improve network reliability. To avoid routing loops, make sure the route reflectors in a cluster have
the same cluster ID.
Perform this task on PE devices.
To configure a BGP MDT route reflector:
Step
Enter system view.
1.
Enter BGP instance view.
2.
Enter BGP IPv4 MDT
3.
address family view.
Configure the device as a
4.
route reflector and specify its
peers or peer groups as
clients.
(Optional.) Disable route
5.
reflection between clients.
(Optional.) Configure the
6.
cluster ID of the route
reflector.

Displaying and maintaining multicast VPN

Execute display commands in any view and reset commands in user view.
Task
Display BGP MDT peer group
information.
Display information about BGP
MDT peers or peer groups.
Display BGP MDT routing
information.
Display information about BGP
update groups for the BGP IPv4
MDT address family.
Display information about
data-groups that are received in
the MD of a VPN instance for IPv4
multicast transmission.
Display information about
data-groups that are received in
the MD of a VPN instance for IPv6
multicast transmission.
Command
system-view
bgp as-number [ instance
instance-name ]
address-family ipv4 mdt
peer { group-name | ip-address
[ mask-length ] } reflect-client
undo reflect between-clients
reflector cluster-id { cluster-id |
ip-address }
Command
display bgp [ instance instance-name ] group ipv4 mdt
[ group-name group-name ]
display bgp [ instance instance-name ] peer ipv4 mdt [ ip-address
mask-length | { ip-address | group-name group-name } log-info |
[ ip-address ] verbose ]
display bgp [ instance instance-name ] routing-table ipv4 mdt
[ route-distinguisher route-distinguisher ] [ ip-address
[ advertise-info ] ]
display bgp [ instance instance-name ] update-group ipv4 mdt
[ ip-address ]
display multicast-domain vpn-instance vpn-instance-name
data-group receive [ brief | [ active | group group-address | sender
source-address | vpn-source-address [ mask { mask-length | mask } ] |
vpn-group-address [ mask { mask-length | mask } ] ] * ]
display multicast-domain vpn-instance vpn-instance-name ipv6
data-group receive [ brief | [ active | group group-address | sender
source-address | vpn-source-address [ mask-length ] |
vpn-group-address [ mask-length ] ] * ]
156
Remarks
N/A
N/A
N/A
By default, neither route reflectors
nor clients exist.
By default, route reflection between
clients is disabled.
For more information about this
command, see Layer 3—IP
Routing Command Reference.
By default, a route reflector uses its
router ID as the cluster ID.
For more information about this
command, see Layer 3—IP
Routing Command Reference.