Md Vpn Inter-As Option C Configuration Example - HP VSR1000 Configuration Manual

232.3.3.3
# Display information about the remote default-group for IPv4 multicast transmission in each VPN
instance on PE 1.
[PE1] display multicast-domain default-group remote
MD remote default-group information:
Group address
232.1.1.1
232.3.3.3
# Display information about the local default-group for IPv4 multicast transmission in each VPN
instance on PE 4.
[PE4] display multicast-domain default-group local
MD local default-group information:
Group address
232.1.1.1
233.3.3.3
# Display information about the remote default-group for IPv4 multicast transmission in each VPN
instance on PE 4.
[PE4] display multicast-domain default-group remote
MD remote default-group information:
Group address
232.1.1.1
232.3.3.3

MD VPN inter-AS option C configuration example

Network requirements
As shown in
Item
Multicast sources
and receivers
VPN instances to
which PE interfaces
belong
Unicast routing
protocols and
MPLS
1.1.1.1
Source address
4.4.4.4
4.4.4.4
Source address
4.4.4.4
4.4.4.4
Source address
1.1.1.1
1.1.1.1
Figure 65, configure MD VPN inter-AS option C to meet the following requirements:
Network requirements
•
In VPN instance a, S 1 is a multicast source, and R 2 is a receiver.
•
In VPN instance b, S 2 is a multicast source, and R 1 is a receiver.
•
For VPN instance a, the default-group is 239.1.1.1, and the data-group range is
225.1.1.0 to 225.1.1.15.
•
For VPN instance b, the default-group is 239.4.4.4, and the data-group range is
225.4.4.0 to 225.4.4.15.
•
PE 1: GigabitEthernet 1/0/2 belongs to VPN instance a. GigabitEthernet 1/0/3
belongs to VPN instance b. GigabitEthernet 1/0/1 and Loopback 1 belong to the
public network instance.
•
PE 2: GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, Loopback 1, and Loopback 2
belong to the public network instance.
•
PE 3: GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, Loopback 1, and Loopback 2
belong to the public network instance.
•
PE 4: GigabitEthernet 1/0/2 belongs to VPN instance a. GigabitEthernet 1/0/3
belongs to VPN instance b. GigabitEthernet 1/0/1 and Loopback 1 belong to the
public network instance.
•
Configure OSPF separately in AS 100 and AS 200, and configure OSPF
between the PEs and CEs.
•
Establish BGP peer connections between PE 1, PE 2, PE 3, and PE 4 on their
respective Loopback 1.
•
Configure MPLS separately in AS 100 and AS 200.
MTunnel1 b
Next hop VPN instance
2.2.2.2 a
2.2.2.2 b
Interface VPN instance
MTunnel0 a
MTunnel1 b
Next hop VPN instance
3.3.3.3 a
3.3.3.3 b
198