Configuring Ipv6 Pim-Ssm; Ipv6 Pim-Ssm Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Pim-Sm - HP VSR1000 Configuration Manual

Step
Disable the device from
3.
forwarding BSMs out of their
incoming interfaces.

Configuring IPv6 PIM-SSM

IPv6 PIM-SSM requires MLDv2 support. Enable MLDv2 on IPv6 PIM routers that connect to
multicast receivers.

IPv6 PIM-SSM configuration task list

Tasks at a glance
(Required.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure IPv6 PIM-SSM, configure an IPv6 unicast IPv6 routing protocol so that all
devices in the domain can interoperate at the network layer.

Enabling IPv6 PIM-SM

Before you configure IPv6 PIM-SSM, you must enable IPv6 PIM-SM, because the implementation of
the IPv6 SSM model is based on subsets of IPv6 PIM-SM.
When you deploy an IPv6 PIM-SSM domain, enable IPv6 PIM-SM on non-border interfaces of the
routers.
IMPORTANT:
All the interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Step
Enter system view.
1.
Enable IP multicast routing,
2.
and enter MRIB view.
Return to system view.
3.
Enter interface view.
4.
Enable IPv6 PIM-SM.
5.
Enabling IPv6 PIM-SM
Configuring the IPv6 SSM group range
Configuring common IPv6 PIM features
Command
undo bsm-reflection enable
Command
system-view
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
ipv6 pim sm
297
Remarks
By default, the device forwards
BSMs out of their incoming
interfaces.
Remarks
N/A
By default, IPv6 multicast routing
is disabled.
N/A
N/A
By default, IPv6 PIM-SM is
disabled.