Configuring Multicast Load Splitting On An Igmp Proxy; Configuring Multicast Access Control; Configuration Prerequisites; Enabling Multicast Access Control - HP VSR1000 Configuration Manual

Configuring multicast load splitting on an IGMP proxy

This feature enables all proxy interfaces on an IGMP proxy device to share multicast traffic on a
per-group basis.
To enable multicast load splitting on an IGMP proxy device:
Step
Enter system view.
1.
Enter IGMP view.
2.
Enable multicast load splitting.
3.

Configuring multicast access control

Configure the multicast access control feature on the BRAS.

Configuration prerequisites

Before you configure the multicast access control feature, complete the following tasks:
Configure a unicast routing protocol so that all devices in the domain can interoperate at the
1.
network layer.
Configure basic IGMP features. Do not specify IGMPv1 because IGMPv1 does not support
2.
IGMP querier election.

Enabling multicast access control

Perform this task on an interface of the BRAS where you want to control the downstream users'
access to multicast traffic.
To enable multicast access control:
Step
Enter system view.
1.
Enter Layer 3 Ethernet
2.
interface view, Layer 3
Ethernet subinterface view,
Layer 3 aggregate interface
view, Layer 3 aggregate
subinterface view, or VT
interface view.
Enable multicast access
3.
control.
Command
system-view
igmp [ vpn-instance
vpn-instance-name ]
proxy multipath
Command
system-view
interface interface-type
{ interface-number |
interface-number.subnumber }
igmp authorization-enable
49
Remarks
N/A
N/A
By default, multicast load splitting
is disabled, and only the proxy
interface with the highest IP
address on the IGMP proxy
device forwards multicast data.
Remarks
N/A
N/A
By default, multicast access
control is disabled.