Configuring A Vlan-Based Static Group Member - HP VSR1000 Configuration Manual

Step
Enter Layer 3 Ethernet
2.
interface view, Layer 3
Ethernet subinterface view,
Layer 3 aggregate interface
view, or Layer 3 aggregate
subinterface view.
Enable per-session IPv6
3.
multicast forwarding.

Configuring a VLAN-based static group member

In access-controlled IPv6 multicast, IPv6 multicast packets are VLAN-tagged. When you configure a
subinterface on the BRAS as a VLAN-based static group member, you must specify the VLANs to
which the subinterface belongs. Otherwise, the subinterface cannot join the IPv6 multicast group,
and the static IPv6 multicast forwarding entry cannot be created.
Configuration guidelines
When you configure a subinterface as a VLAN-based static group member, follow these restrictions
and guidelines:
•
When you configure a subinterface as a non-VLAN-based static member interface, do not
configure the mld join-by-session or mld user-vlan-aggregation dot1q command on the
subinterface. Otherwise, IPv6 static multicast forwarding entries cannot be created.
•
When you configure a subinterface as a VLAN-based static member interface, you must also
configure the mld join-by-session or mld user-vlan-aggregation dot1q command on the
subinterface. An IPv6 static multicast forwarding entry can be created under either of the
following conditions:
When the mld join-by-session command is configured, users that belong to the specified
VLANs log in.
When the user-vlan-aggregation dot1q command is configured, the specified VLAN IDs
are the same as or are included in the VLAN IDs specified in the mld static-group
command.
Configuration procedure
To configure an interface as a VLAN-based static group member:
Step
Enter system view.
1.
Enter Layer 3 Ethernet
2.
subinterface view or Layer 3
aggregate subinterface view.
Configure the subinterface as
3.
a VLAN-based static group
member.
Command
interface interface-type
{ interface-number |
interface-number.subnumber }
mld join-by-session
Command
system-view
interface interface-type
{ interface-number |
interface-number.subnumber }
mld static-group
ipv6-group-address [ source
ipv6-source-address ] { dot1q vid
vlan-list | dot1q vid vlan-id
second-dot1q vlan-list }
244
Remarks
N/A
By default, per-session IPv6
multicast forwarding is
enabled.
Remarks
N/A
N/A
By default, a subinterface is
not a VLAN-based static group
member for any IPv6 multicast
groups or IPv6 multicast
source and groups.