HP VSR1000 Configuration Manual page 132

Figure 46 Network diagram
Receiver 1
Host A
Source 1
Table 14 Interface and IP address assignment
Device
Router A
Router A
Router B
Router B
Router B
Router C
Router C
Router C
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the routers in the BIDIR-PIM domain. (Details not shown.)
2.
Enable IP multicast routing, PIM-SM, BIDIR-PIM, and IGMP:
3.
# On Router A, enable IP multicast routing, enable PIM-SM on each interface, and enable
BIDIR-PIM.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim sm
[RouterA-GigabitEthernet1/0/2] quit
[RouterA] pim
[RouterA-pim] bidir-pim enable
Router B
GE1/0/1 GE1/0/3
GE1/0/2
GE1/0/2
GE1/0/1
Router A
Interface IP address
GE1/0/1 192.168.1.1/24
GE1/0/2 10.110.1.1/24
GE1/0/1 192.168.2.1/24
GE1/0/2 10.110.1.2/24
GE1/0/3 10.110.2.1/24
GE1/0/1 10.110.2.2/24
GE1/0/2 10.110.3.1/24
Loop0 1.1.1.1/32
Loop0
GE1/0/1
GE1/0/2
BIDIR-PIM
GE1/0/3
Router D
Device Interface
Router D GE1/0/1
Router D GE1/0/2
Router D GE1/0/3
Source 1 —
Source 2 —
Receiver 1 —
Receiver 2 —
124
Receiver 2
Router C
Host B
Source 2
GE1/0/2
IP address
192.168.3.1/24
192.168.4.1/24
10.110.3.2/24
192.168.1.100/24
192.168.4.100/24
192.168.2.100/24
192.168.3.100/24
Figure 46. (Details not