HP VSR1000 Configuration Manual page 317

•
Host A and Host C are multicast receivers on the stub networks N1 and N2.
•
Specify GigabitEthernet 1/0/3 on Router E as a C-BSR and a C-RP. The C-RP is designated to
IPv6 multicast group range FF0E::101/64. Specify GigabitEthernet 1/0/2 of Router D as the
static RP on all the routers to back up the dynamic RP.
•
MLDv1 runs between Router A and N1, and between Router B, Router C, and N2.
Figure 95 Network diagram
Table 28 Interface and IPv6 address assignment
Device
Router A
Router A
Router A
Router B
Router B
Router C
Router C
Configuration procedure
Assign an IPv6 address and prefix length to each interface, as shown in
1.
shown.)
Configure OSPFv3 on all routers in the IPv6 PIM-SM domain. (Details not shown.)
2.
Enable IPv6 multicast routing, and enable MLD and IPv6 PIM-SM:
3.
# On Router A, enable IPv6 multicast routing.
<RouterA> system-view
Interface IPv6 address
GE1/0/1 1001::1/64
GE1/0/2 1002::1/64
GE1/0/3 1003::1/64
GE1/0/1 2001::1/64
GE1/0/2 2002::1/64
GE1/0/1 2001::2/64
GE1/0/2 3001::1/64
Device Interface
Router D GE1/0/1
Router D GE1/0/2
Router D GE1/0/3
Router E GE1/0/1
Router E GE1/0/2
Router E GE1/0/3
Router E GE1/0/4
309
IPv6 address
4001::1/64
1002::2/64
4002::1/64
3001::2/64
2002::2/64
1003::2/64
4002::2/64
Figure 95. (Details not