HP VSR1000 Configuration Manual page 63

Configure the IGMP SSM mapping feature on Router D so that the receiver host can receive
multicast data only from Source 1 and Source 3.
Figure 24 Network diagram
Source 2
Source 1
Table 7 Interface and IP address assignment
Device
Source 1
Source 2
Router A
Router A
Router A
Router B
Router B
Router B
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the routers in the PIM-SM domain. (Details not shown.)
2.
Enable IP multicast routing, PIM-SM, and IGMP:
3.
# On Router D, enable IP multicast routing.
<RouterD> system-view
[RouterD] multicast routing
[RouterD-mrib] quit
# Enable IGMPv3 on the receiver-side interface (GigabitEthernet 1/0/1).
[RouterD] interface gigabitethernet 1/0/1
[RouterD-GigabitEthernet1/0/1] igmp enable
[RouterD-GigabitEthernet1/0/1] igmp version 3
[RouterD-GigabitEthernet1/0/1] quit
# Enable PIM-SM on the other interfaces.
[RouterD] interface gigabitethernet 1/0/2
[RouterD-GigabitEthernet1/0/2] pim sm
[RouterD-GigabitEthernet1/0/2] quit
Router B
GE1/0/1 GE1/0/3
GE1/0/2
PIM-SM
GE1/0/2
GE1/0/1 GE1/0/3
Router A
Interface IP address
— 133.133.1.1/24
— 133.133.2.1/24
133.133.1.2/24
GE1/0/1
192.168.1.1/24
GE1/0/2
192.168.4.2/24
GE1/0/3
133.133.2.2/24
GE1/0/1
192.168.1.2/24
GE1/0/2
192.168.2.1/24
GE1/0/3
Router C
GE1/0/3 GE1/0/1
GE1/0/2
GE1/0/2
GE1/0/3 GE1/0/1
Router D
Device
Source 3
Receiver
Router C
Router C
Router C
Router D
Router D
Router D
55
Source 3
Receiver
Interface IP address
— 133.133.3.1/24
— 133.133.4.1/24
133.133.3.2/24
GE1/0/1
192.168.3.1/24
GE1/0/2
192.168.2.2/24
GE1/0/3
133.133.4.2/24
GE1/0/1
192.168.3.2/24
GE1/0/2
192.168.4.1/24
GE1/0/3
Figure 24. (Details not