HP VSR1000 Configuration Manual page 121

Figure 43 Network diagram
Source
10.110.5.100/24
Table 11 Interface and IP address assignment
Device
Router A
Router A
Router B
Router B
Router C
Configuration procedure
Assign an IP address and subnet mask for each interface, as shown in
1.
shown.)
Configure OSPF on the routers in the PIM-DM domain. (Details not shown.)
2.
Enable IP multicast routing, IGMP, and PIM-DM:
3.
# On Router A, enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable IGMP on the receiver-side interface (GigabitEthernet 1/0/1).
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] igmp enable
[RouterA-GigabitEthernet1/0/1] quit
# Enable PIM-DM on GigabitEthernet 1/0/2.
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
GE1/0/1 GE1/0/3
Router D
PIM-DM
Interface IP address
GE1/0/1 10.110.1.1/24
GE1/0/2 192.168.1.1/24
GE1/0/1 10.110.2.1/24
GE1/0/2 192.168.2.1/24
GE1/0/1 10.110.2.2/24
Router A
GE1/0/1
GE1/0/2 GE1/0/1
Router B
GE1/0/1
Router C
Device
Router C
Router D
Router D
Router D
Router D
113
Receiver
Host A
Host B
Receiver
Host C
Host D
Interface IP address
GE1/0/2 192.168.3.1/24
GE1/0/1 10.110.5.1/24
GE1/0/2 192.168.1.2/24
GE1/0/3 192.168.2.2/24
GE1/0/4 192.168.3.2/24
Figure 43. (Details not