HP VSR1000 Configuration Manual page 124

•
IGMPv2 runs between Router A and N1, and between Router B, Router C, and N2.
Figure 44 Network diagram
Source
10.110.5.100/24
Table 12 Interface and IP address assignment
Device
Router A
Router A
Router A
Router B
Router B
Router C
Router C
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on all routers in the PIM-SM domain. (Details not shown.)
2.
Enable IP multicast routing, IGMP and PIM-SM:
3.
# On Router A, enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable IGMP on the receiver-side interface (GigabitEthernet 1/0/1).
[RouterA] interface gigabitethernet 1/0/1
GE1/0/1 GE1/0/4
GE1/0/3
Router D
PIM-SM
Interface IP address
GE1/0/1 10.110.1.1/24
GE1/0/2 192.168.1.1/24
GE1/0/3 192.168.9.1/24
GE1/0/1 10.110.2.1/24
GE1/0/2 192.168.2.1/24
GE1/0/1 10.110.2.2/24
GE1/0/2 192.168.3.1/24
Router A
GE1/0/1
GE1/0/3
GE1/0/3
GE1/0/2
GE1/0/2
GE1/0/1
Router E
GE1/0/2
GE1/0/1
Router C
Device
Router D
Router D
Router D
Router E
Router E
Router E
Router E
116
Receiver
Host A
Host B
Receiver
GE1/0/1
Router B
Host C
Host D
Interface
GE1/0/1
GE1/0/2
GE1/0/3
GE1/0/1
GE1/0/2
GE1/0/3
GE1/0/4
Figure
IP address
10.110.5.1/24
192.168.1.2/24
192.168.4.2/24
192.168.3.2/24
192.168.2.2/24
192.168.9.2/24
192.168.4.1/24
44. (Details not