Setup; Connect Appliance To The Network And Determine Ip Address - NetSHIELD Branch PRO User Manual

S
ETUP

Connect appliance to the network and determine IP address

1. Plug power cord into the power jack in the rear of the NetSHIELD appliance, and into
a 3-prong grounded outlet.
2. Connect your local area network cable to the eth0 port on the NetSHIELD appliance.
Network cable must be Type RJ -45, category 5 cable or higher.
3. Connect a monitor to the VGA port on the NetSHIELD™ appliance.
4. Connect a keyboard to the USB ports.
5. Boot the appliance by pushing the red Start button on the left side of the front panel.
6. The green Power light will come on. The yellow Disk Activity indicator will also flash.
7. The front panel lights (from right to left) are:

Power

Hard Drive Activity

Network Activity 1

Network Activity 2

System Overheat
8. The appliance will run through its startup, displaying its progress on the monitor. When
it is finished, a screen like the following will appear.
Ten Tara Boulevard, Suite 140
Nashua NH 03062
Copyright © 2017 SnoopWall, Inc.
Page | 2