Adding Ip Addresses Manually - NetSHIELD Branch PRO User Manual


After you run an asset discovery process, you may want to manually add more IPs.

You can manually add IP addresses by selecting Network Access Control
Assets. This takes you to the System Information screen.

The IP Address field is required.

If you are unsure of the MAC address, click the Detect MAC button after you enter the IP
address. The MAC address may be filled in for you if the asset is online. If you have to add
an asset manually because the Asset Discovery process failed to find it, the Detect MAC
button will probably not find it either.

Host Name, Operating System, and Manufacturer may also be filled in automatically,
depending on current information available for that IP Address.
Note: Required fields (marked with an asterisk) must contain information. After
you add system data, check the System Information page again. The MAC
Address, Host Name, Operating System, and Manufacturer may be filled in for
you. We strongly recommend you only change the MAC Address and Host Name
fields if it is absolutely necessary.

Fill in the remaining fields on the page. The table below gives an overview for each field.
Ten Tara Boulevard, Suite 140
Nashua NH 03062
A IP A
DDING DDRESSES
M
ANUALLY
Copyright © 2017 SnoopWall, Inc.

Add
Page | 30