Stopping Audits In-Process; Factory Reset; Reset Console Password - NetSHIELD Branch PRO User Manual

You are asked to confirm or cancel the shutdown. If you proceed, SnoopWall NetSHIELD
operating system will shut down. Manually press the power button to power off.
To restart SnoopWall NetSHIELD, you must manually press the Power button on the appliance.
Shutting down does not change the Scheduled or Inactive status of any audit. Any audits in
process when the shutdown occurs will stop. You must restart them when SnoopWall
NetSHIELD is powered up again.

Stopping Audits In-Process

To terminate audits currently running:

Select System
(You can also halt an audit on the Manage Audits page by clicking the Stop button.)

Click the Stop All Audits button.
You are asked to confirm or cancel the action.
Any audits currently in process do not complete. You
receive a warning saying in-process audits will stop and
must be restarted later.
Any reports already generated remain on the system. You may still view them by selecting

Reports View Audit Results.
A halted audit does not run again until its next scheduled time. Halting all audits does not
change their Scheduled or Inactive status.
To restart an audit sooner than the next scheduled time:


Select Audits

Select the audit to open it in the Audit Wizard. Click through Audit Wizard pages until you
reach the screen with audit frequency settings. Set the Frequency of Audit to Now.

Click Next until you complete the Audit Wizard steps, and Save the audit. When the
Manage Audits page opens, click the Start button to begin the audit.

Factory Reset

To return SnoopWall NetSHIELD to the settings with which it was shipped, select System
Utilities from the left menu, and then click Factory Settings.
Important Note: Alerts should always be cleared from the command center
following a factory reset on the client appliance.
Just as with the console factory reset, you will be given the option of retaining the Company
Information, Notification Information, and the appliance name. All the asset information,
categories, audits, reports, etc. will be deleted.

Reset Console Password

To reset the Console Password back to the original changeme, click the Reset Console
Password button on the System
Ten Tara Boulevard, Suite 140
Nashua NH 03062

Utilities from the left menu.
Manage Audits from the left menu.

Utilities page.

Copyright © 2017 SnoopWall, Inc.
Page | 13