Quick Start Installation And Operating Guide - Klein 5000 SERIES Operation And Maintenance Manual

injury may occur to the operator as a result of this action.
Review "General Rigging Notes and Cautions" on page 3-5 before performing the
following procedures.
Turn the system power off.
1.
2. Disconnect the safety cable from the bail grip loop. Remove the electrical tape
securing the safety cable to the tow cable. Cable ties fastening the safety cable to
the cable hold-down clips on the towfish housing may remain in place.
3. Separate the connectors by first loosening the locking sleeve. Then double check
that the TPU is off and grasp the body of the connector and gently pull it out of
the tow shackle connector. Do not pull on the wires to separate the connectors.
Always hold the body of the connector. After separating the connectors, put a thin
coating of silicone grease on the rubber section of the connector pins.
4. Remove the retaining ring from the tow pin and withdraw the pin. Disengage the
tow cable shackle from the towfish or tow bracket. Replace the tow pin in the
hole in the tow bracket, and secure it with the retaining ring.
Refer to the current revision of the "SonarPro User Manual" (P/N 11210079)
before powering up.
3.5

Quick Start Installation and Operating Guide

3.5.1
Refer to Figure D-1 on page D-3 and to Figure D-2 on page D-4 in APPENDIX D:
"General Setup, Configuration and Troubleshooting."
To install the hardware:
1. Install the TPU, the Ethernet Hub and the Computer Display and Control
Unit (computer) in the deck house of the towing vessel.
2. Verify the ship power voltage with a voltmeter.
3. Check that
voltage. The hub must have the proper transformer (115 or 220 VAC to
12 VDC).
4. Connect the Ethernet Hub to the power source and check that the power light is
lit.
Quick Start Installation and Operating Guide
WARNING Power to the sonar system must be turned off prior to
connection or disconnection of the tow cable to either the towfish or the
TPU, as serious damage may occur to the sonar system electronics or
Hardware Installation
the TPU, the Ethernet Hub and the computer are set to the proper
3-9