Operator Controls And Indicators - Klein 5000 SERIES Operation And Maintenance Manual

5-4
CHAPTER 5 Splashproof TPU
MAG OUT:
DEBUG:
GPS IN:
120/240 VAC:
12 VDC:
5.1.3
Most of operator controls and one indicator are located on the connector panel of
the Splashproof TPU as shown in Figure 5-4 on page 5-3. They are the following:
PWR:
VAC/12 VDC:
RUN/STAND BY:
Series 5000 Sonar System Operations and Maintenance Manual
6-pin bulkhead connector that connects to a
magnetometer. (Not used.)
3-pin bulkhead connector that connects to the serial
port of a computer and can be used to view and save
the boot sequence data using HyperTerminal.
This connector is internally wired to an RJ-45
connector that connects to the DBUG connector of
the CPU board.
8-pin bulkhead connector for receiving navigation
data.
This connector is internally wired to a 9-pin DSUB
connector that connects to the COM2 connector of
the Transition board and to the output of the
12 VDC power supply.
3-pin bulkhead connector that connects to either a
115 or 230 VAC, 50–60 Hz power source.
6-pin bulkhead connector that connects to a
12 VDC, 1.5 A power source

Operator Controls and Indicators

Green indicator that is illuminated when either AC
or DC power is on.
3-position switch that when switched to VAC,
selects AC power to power the TPU, and when
switched to 12 VDC, selects DC power to power the
TPU. Power is applied in accordance with the
RUN/STAND BY switch position. With the switch
in the center position, the power is off.
2-position switch that when switched to STAND BY,
powers the GPS and the baffle fan after switching
the VAC/12 VDC switch from off to VAC or
12 VDC. When switched to RUN, applies power to
the rest of the components in the TPU. This switch
should be in the STAND BY position when the
VAC/12 VDC switch is switched from off to VAC or
12 VDC.
P/N 11210060, Rev. 16