Klein 5000 SERIES Operation And Maintenance Manual page 158

D-44
APPENDIX D General Setup, Configuration and Troubleshooting
assembly screws into the end cap and extracts the electronics. When flipped
over, the assembly pushes the electronics end cap into the pressure housing.
2. Position the post with the unthreaded hole to the top.
3. Study the jacking screw. You will notice the threads are off center. Locate the
short, unthreaded side.
4. Insert the short end of the
jacking screw, which is
shown in Figure D-18,
through the post.
5. Thread the jacking screw
into the electronics housing
feed-thru.
6. Place the washer onto the
jacking screw, thread the
nut on and tighten the nut.
This will extract the
electronics housing.
To reassemble the electronics
into the pressure housing:
1. Slide the electronics gently
and carefully into the
pressure bottle, aligning the alignment pin with the notch in the pressure housing.
2. Position the post with the threaded hole to the top, and thread the jacking screw
into the post with the long, unthreaded section entering the feed-thru.
3. Tighten the jacking screw to push the electronics into the pressure housing. Stop
when flush.
4. Thread the washer and nut onto the jacking screw and hand tighten.
5. Replace the nose cone.
Series 5000 Sonar System Operations and Maintenance Manual
CAUTION When tightening the jacking screw as described below, do not
over tighten.
Figure D-18:
Jacking Screw
P/N 11210060, Rev. 16