Table of Contents
Advertisement
CHAPTER 3: I
This chapter provides instructions for unpacking, installing and connecting the
components of the Series 5000 AUV V2 Sonar System. In addition, a startup
procedure is provided for getting the system up and running.
3.1
Unpacking and Inspection
3.1.1
Remove the Sonar Electronics from the shipping container and set it on a sturdy,
flat surface. Inspect it for signs of damage. If there is any damage to the Sonar
Electronics or if any items are missing, immediately contact Klein Marine Systems
or your sales representative.
3.1.2
Remove the Sonar Processor from the shipping container and set it on a sturdy, flat
surface. Inspect it for signs of damage. If there is any damage to the Sonar
Processor or if any items are missing, immediately contact Klein Marine Systems or
your sales representative.
3.2
Mechanical Installation of the Sonar Electronics
and the Sonar Processor
3.2.1
The Sonar Electronics and the Sonar Processor are each enclosed in a pressure
case suitable for operation under hydrostatic pressure. Mounting of the pressure
cases should be such that as to minimize strain due to cable bending and pulling.
3.2.2
The Sonar Electronics and the Sonar Processor should not be subjected to
excessive vibration or shock loading.
NSTALLATION AND
Unpacking the Sonar Electronics
Unpacking the Sonar Processor
Mounting
Isolating from Shock and Vibration
3-1
S
TARTUP
Advertisement
Table of Contents
