Table of Contents
Advertisement
Chapter 7 Wireless LAN
The following table describes the wireless LAN security labels in this screen.
Table 32 Wireless LAN > General: WPA(2)-PSK
LABEL
Auto Generate
Key
Security Mode
Active
Compatible
Encryption
Pre-Shared Key
Group Key
Update Timer
7.4.4 WPA(2) Authentication
Use this screen to configure and enable WPA or WPA2 authentication; click the
Wireless LAN link under Network to display the General screen. Select WPA or
WPA2 from the Security Mode list.
Note: WPA or WPA2 is not available if you enable WPS before you configure WPA or
WPA2 in the Wireless LAN > General screen.
148
DESCRIPTION
This field is only available for WPA-PSK.
Select this option to have the CellPipe 7130 RG automatically generate
an SSID and pre-shared key. The SSID and Pre-Shared Key fields will
not be configurable when you select this option.
Choose WPA-PSK or WPA2-PSK from the drop-down list box.
This field is only available for WPA2-PSK. Select this if you want the
CellPipe 7130 RG to support WPA-PSK and WPA2-PSK simultaneously.
Select the encryption type (TKIP, AES or TKIP+AES) for data
encryption.
Select TKIP if your wireless clients can all use TKIP.
Select AES if your wireless clients can all use AES.
Select TKIP+AES to allow the wireless clients to use either TKIP or
AES.
The encryption mechanisms used for WPA(2) and WPA(2)-PSK are the
same. The only difference between the two is that WPA(2)-PSK uses a
simple common password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols).
The Group Key Update Timer is the rate at which the AP sends a new
group key out to all clients.
CellPipe 7130 RG User's Guide
Advertisement
Table of Contents
Troubleshooting
