ZyXEL Communications CellPipe 7130 RG User Manual page 95

The following table describes the labels in this screen.
Table 9 Status > WAN Service Statistics
LABEL
Interface
Description
Received
Bytes
Pkts
Errs
Drops
Transmitted
Bytes
Pkts
Errs
Drops
Close
Refresh
Interval
Set Interval
Stop
CellPipe 7130 RG User's Guide
DESCRIPTION
This shows the name of the WAN interface used by this connection.
A default name ipoa0, pppoa1, atmx (where x starts from 0 and is the
index number of ATM layer-2 interfaces using different VPI and/or VCI
values) or ptm0 indicates the DSL port. The pppx name (where x starts
from 0 and is the index number of PPP connection on the CellPipe 7130
RG) indicates a PPP connection via any one of the WAN interface. eth4
indicates the Ethernet WAN interface (the physical Ethernet WAN port).
The number after the dot (.) represents the VLAN ID number assigned to
traffic sent through this connection. The number after the underscore
(_) represents the index number of connections through the same
interface.
(null) means the entry is not valid.
This shows the descriptive name of this connection.
0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last
number represents the index number of connections over the same PVC
or the VLAN ID number assigned to traffic sent through this connection.
(null) means the entry is not valid.
This indicates the number of bytes received on this interface.
This indicates the number of transmitted packets on this interface.
This indicates the number of frames with errors received on this
interface.
This indicates the number of received packets dropped on this interface.
This indicates the number of bytes transmitted on this interface.
This indicates the number of transmitted packets on this interface.
This indicates the number of frames with errors transmitted on this
interface.
This indicates the number of outgoing packets dropped on this interface.
Click this to close the window.
Enter the time interval for refreshing statistics in this field.
Click this button to apply the new poll interval you entered in the
Refresh Interval field.
Click Stop to stop refreshing statistics.
Chapter 4 Status Screens
95