ZyXEL Communications CellPipe 7130 RG User Manual page 218

Chapter 15 RIP
The following table describes the labels in this screen.
Table 67 Advanced > RIP
LABEL
Interface
Version
Operation
Enabled
Apply/Save
218
DESCRIPTION
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the
RIP packets that the CellPipe 7130 RG sends (it recognizes both formats
when receiving). RIP version 1 is universally supported but RIP version 2
carries more information. RIP version 1 is probably adequate for most
networks, unless you have an unusual network topology.
Select Passive to have the CellPipe 7130 RG update the routing table
based on the RIP packets received from neighbors but not advertise its
route information to other routers in this interface.
Select Active to have the CellPipe 7130 RG advertise its route
information and also listen for routing updates from neighboring routers.
Select the check box to activate the settings.
Click Apply/Save to save your changes back to the CellPipe 7130 RG.
CellPipe 7130 RG User's Guide