Static Route Edit - ZyXEL Communications CellPipe 7130 RG User Manual

13.2.1 Static Route Edit

Click the Add button in the Static Route screen. Use this screen to configure the
required information for a static route.
Figure 83 Static Route: Add
The following table describes the labels in this screen.
Table 64 Static Route: Add
LABEL
Destination IP
Address
IP Subnet
Mask
Use Interface
Use Gateway
IP Address
Back
Apply
Cancel
CellPipe 7130 RG User's Guide
DESCRIPTION
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Enter the IP subnet mask here.
Select a WAN interface through which the traffic is sent. You must have
the WAN interface(s) already configured in the WAN screens.
Select this option and enter the IP address of the next-hop gateway. The
gateway is a router or switch on the same segment as your CellPipe 7130
RG's interface(s). The gateway helps forward packets to their
destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the CellPipe 7130 RG.
Click Cancel to begin configuring this screen afresh.
Chapter 13 Static Route
211