The Reset Button; The Wlan Button; The Wps Button - ZyXEL Communications CellPipe 7130 RG User Manual

Chapter 1 Introducing the CellPipe 7130 RG

1.7 The RESET Button

If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "telus".
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.

1.8 The WLAN Button

You can use the WLAN button of the device to turn the wireless LAN off or on.
Make sure the POWER LED is on (not blinking).
1
Press the WLAN button for one second and release it. The WLAN LED should
2
change from on to off or vice versa. Refer to
information.

1.9 The WPS Button

You can use the WPS button to activate WPS in order to quickly set up a wireless
network with strong security.
Make sure the POWER LED is on (not blinking).
1
Make sure the wireless LAN is turned on. Refer to
2
Section 7.4 on page 143
Press the WPS button for more than one second and release it. Press the WPS
3
button on another WPS -enabled device within range of the CellPipe 7130 RG. The
WPS LED should flash while the CellPipe 7130 RG sets up a WPS connection with
the wireless device. Refer to
You must activate WPS in the CellPipe 7130 RG and in another wireless device within
two minutes of each other. See
28
Section 7.4 on page 143
for information or check that the WLAN LED is on.
Section 7.6 on page 153
Section 7.10.4 on page 163
for more
Section 1.8 on page 28
for more information.
for more information.
CellPipe 7130 RG User's Guide
and