Creating Incoming Firewall Rules - ZyXEL Communications CellPipe 7130 RG User Manual

Chapter 11 Firewall
Table 52 Firewall > Incoming (continued)
LABEL
Add
Apply

11.3.1 Creating Incoming Firewall Rules

In the Incoming screen, click Add to display this screen and refer to the following
table for information on the labels.
Figure 70 Firewall > Incoming: Add
The following table describes the labels in this screen.
Table 53 Firewall > Incoming: Add
LABEL
Active
Filter Name
Protocol
Source IP
Address
Source Subnet
Mask
194
DESCRIPTION
Click Add to create a new rule.
Click Apply to save your changes back to the CellPipe 7130 RG.
DESCRIPTION
Select this check box to enable the rule.
Enter a descriptive name of up to 16 printable English keyboard
characters, including spaces.
To add a firewall rule, you need to configure at least one of the
following fields (except the Interface field).
Select the transport layer protocol (TCP/UDP, TCP, UDP or ICMP)
and enter the protocol (service type) number in the port field. Select
NONE to apply the rule to any protocol.
Enter the source IP address in dotted decimal notation.
Enter the source subnet mask.
CellPipe 7130 RG User's Guide