Table of Contents
Advertisement
Chapter 10 Media Server
10.1.1 What You Can Do in this chapter
• Use the Media Server Configuration screen
enable the media server on the CellPipe 7130 RG.
• Use the Remove Disk Safely screen
disconnect the USB device from the CellPipe 7130 RG.
10.1.2 Before You Begin
Make sure the CellPipe 7130 RG is connected to your network and turned on.
Connect the USB device to one of the CellPipe 7130 RG's USB ports. Make sure the
1
CellPipe 7130 RG is connected to your network.
The CellPipe 7130 RG detects the USB device and makes its contents available for
2
browsing. If you are connecting a USB hard drive that comes with an external
power supply, make sure it is connected to an appropriate power source that is on.
Note: If your USB device cannot be detected by CellPipe 7130 RG, see the
troubleshooting for suggestions.
10.2 The Media Server Configuration Screen
Use this screen to enable the media server on your CellPipe 7130 RG. To access
this screen, click USB Services > Media Server.
Figure 67 USB Services > Media Server
188
(Section 10.3 on page
(Section 10.3 on page
CellPipe 7130 RG User's Guide
189) to
189) to safely
Advertisement
Table of Contents
Troubleshooting
