The Connect Screen - ZyXEL Communications CellPipe 7130 RG User Manual

The following table describes the fields in this screen.
Table 15 Network > WAN > Mode
LABEL
WAN Link
Selection
Apply

5.5 The Connect Screen

The CellPipe 7130 RG must have a layer-2 interface to allow users to use the DSL
port or Ethernet WAN port to access the Internet. The Connect screen lets you
choose the layer-2 interface that the CellPipe 7130 RG uses. The layer-2 interface
determines how data is transported, whether in frames (Ethernet) or cells (DSL),
from the source (such as a computer on your LAN) to the destination. The screen
varies depending on the interface type you select.
CellPipe 7130 RG User's Guide
DESCRIPTION
Select how you want to connect to the Internet:
DSL: Select this if you have a DSL account and you want to connect to
the Internet using the DSL port.
Ethernet: Select this if you have a broadband modem or router to
access the Internet. Connect the GigE port to your broadband modem
or router.
Click this button to save your changes.
Chapter 5 WAN Setup
105