Chapter 3 Components And Power Supply; Components; Front Panel - Teldat H2 RAIL Installation Manual

3 Components and power supply

Chapter 3 Components and power supply

This chapter provides information on the chassis and components of the Teldat H2 RAIL. Said information covers
the following:

3.1 Components

3.1.1 Front panel

The following image shows the front panel of the device.
Front panel
Fig. 2:
The elements on the front panel are described in the following table:
Table 1: Front panel elements
Item
POWER
MOD1, MOD2
GPS
MOD3, MOD4
LAN1..LAN4
AUX
RESET
In addition to the connectors, the front panel also contains a set of LEDs, which provides information on the status of
the router.
4
• Components.
• Assembly instructions.
• Power supply.
• RESET button.
• Data connection.
• SIM card installation.
Description
Power connection. For further information on the power connection, please see
source on page 7
WWAN antenna connectors.
The interfaces created are cellular1/x and cellular2/x, respectively.
The type of device installed for each position depends on the commercial configuration.
GPS antenna connector.
WWAN/WLAN antenna connectors.
The interface created is cellular3/x, or wlan3/0, for MOD 3 and cellular4/x, or wlan4/0, for
MOD4.
The type of device installed for each position depends on the commercial configuration.
LAN connector.
DB9 connector, which provides access to the device local console for configuration and
monitoring purposes.
Reset button. For further information on how the reset button operates, please see
Button on page 8
Teldat S.A.
Power
RESET
Teldat H2 RAIL