Delivery, Transport, Installation And Assembly; Delivery; Transport, Installation And Assembly - Meiko UPster U 400 Operating Instructions Manual

Operating Instructions UPster U 400 / U 500 / U 500S
CAUTION!
CAUTION!
CAUTION!
9735077
6

Delivery, transport, installation and assembly

6.1

Delivery

Check that the delivery is complete immediately after receiving it by comparing it to
MEIKO's contract confirmation and/or the delivery note.
If necessary, complain about any missing parts immediately to the shipping company and
notify MEIKO.
Check the entire scope of delivery for any damage that may have occurred during shipping.
In the event of any transport damage please inform MEIKO immediately in writing, and
also send a photo of the damaged parts to MEIKO.
Damaged appliances must not be commissioned.
6.2

Transport, installation and assembly

In order to avoid damage or life-threatening injuries during shipping of the installation, the
following points must be observed:

Transport works must only be performed only by qualified persons observing the
safety instructions.

Observe transport instructions on the packing.

Handle with care.

Unpack the machine.
For safe transport, the machine parts are supported by a special square-timber frame.
The warewashing machine must only be transported on the supplied wooden frame. The
packing is specifically designed to allow the appliances to be moved safely and securely
using a pallet truck.
The enclosed dimensional drawing states the connected load and consumption specifica-
tions of the warewashing machine.
Small quantities of steam may escape through the machine's door. For this reason,
furniture and equipment situated near the door must be protected.
On request, an engineer from your local MEIKO representative is available to install
the machine. An engineer from your local MEIKO Service Centre can install the appli-
ance at the correct point and connect the tables - upon request.
Dishwashing machine installation steps:

The complete unit must be levelled in both directions using a water level.

Compensate for an uneven floor by adjusting the feet.

Table joints must be sealed with detergent-resistant sealing compound (e.g. sili-
cone).
Design and construction subject to change without prior notice
Page
11 44
of