Delivery, Transport, Installation And Assembly; Delivery; Transport, Installation And Assembly - Meiko UPster H 500 Operating Instructions Manual

Operating Instructions UPster H 500 / H 500S
CAUTION!
CAUTION!
CAUTION!
9735020
6

Delivery, transport, installation and assembly

6.1

Delivery

Check that the delivery is complete immediately after receiving it by comparing it to
MEIKO's contract confirmation and/or the delivery note.
If necessary, complain about any missing parts immediately to the shipping company and
notify MEIKO.
Check the entire scope of delivery for any damage that may have occurred during ship-
ping.
In the event of any transport damage please inform MEIKO immediately in writing, and
also send a photo of the damaged parts to MEIKO.
Damaged machines must not be commissioned under any circumstances.
6.2

Transport, installation and assembly

In order to avoid damage or life-threatening injuries during shipping of the installation, the
following points must be observed:

Transport works must only be performed only by qualified persons observing the
safety instructions.

Observe transport instructions on the packing.

Handle with care.

Unpack the machine.
For safe transport, the machine parts are supported by a special square-timber frame.
The machine must only be transported on the supplied wooden frame. The packing is
specifically designed to allow the appliances to be moved safely and securely using a pal-
let truck.
The enclosed dimensional drawing states the connected load and consumption specifica-
tions of the warewashing machine.
Small quantities of steam may escape from the hood of the machine. Furniture and
equipment situated near the hood must be protected.
On request, an engineer from your local MEIKO representative is available to install
the machine. This includes setting up the machine at the location of use and connect-
ing the tables as necessary.
Dishwashing machine installation steps:

The complete unit must be levelled in both directions using a water level.

Compensate for an uneven floor by adjusting the feet.

Table joints must be sealed with detergent-resistant sealing compound (e.g. sili-
cone).
Design and construction subject to change without prior notice!
Page
11 42
of