Transport, Installation And Assembly - Meiko FV 28 G-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
ATTENTION!
ATTENTION!
ATTENTION!
Datei:BA_EcoStar545D-M_9662798_EN_2009-05.doc
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
If necessary, complain about any missing parts immediately to the shipping company and
notify MEIKO.
Examine the appliance for possible transit damage.
Should you suspect any damage has occurred during shipping, you should inform:
 the shipping company,
 and MEIKO
in writing, and also send a photo of the damaged parts to MEIKO.
Damaged appliances must not be commissioned.
6.2

Transport, installation and assembly

In order to avoid damage or life-threatening injuries during shipping of the installation, the
following points must be observed:

The shipping operations may only be carried out by qualified persons who ob-
serve the safety instructions.

Observe transport instructions on the packing.

The appliance must be moved with great care.

Unpack the machine.
In order to ensure safe shipping, the installation parts are placed on a special four-sided
wooden frame.
Incoming goods should only arrive on these wooden frames.Incoming goods should only
arrive on these wooden frames. The packing is specifically designed to allow the appli-
ances to be moved safely and securely using a pallet truck.
The enclosed technical sheet indicates the connection and consumption ratings of the ap-
pliance.
Small quantities of steam may escape from the hood of the appliance. Furniture and
equipment situated near the hood must be protected.
An engineer from your local MEIKO Service Centre can install the appliance at the
correct point and connect the tables - upon request. An engineer from your local
MEIKO Service Centre can install the appliance at the correct point and connect the
tables - upon request.
The following must be observed during the installation of the dishwashing machine:

The complete unit must be levelled in both directions using a water level.

Compensate for an uneven floor by adjusting the feet.

Table joints must be sealed with detergent-resistant sealing compound (e.g. sili-
cone).
W e reserv e the right to change execution and construction!
11/44
9662798